1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Homemade Kiln Parts

Discussion in 'Forges, Ovens, Kilns, & Salt Pots' started by RussGen, Jan 24, 2020.

  1. RussGen

    RussGen New Member

    Likes Received:
    9
    Trophy Points:
    8
    I was in the middle of building a heat treat oven using Scott Kozub's design for his HT3000 when my wife says "why don't you just buy one". It didn't take much time to have one on order. So now I have a fully built brick structure, and all the parts that I ordered online. I'd rather see this go to someone who is just starting out than wasting a lot of money on return postage. I could return the kanthal wire so for that $50 someone can have it all.
     
  2. dancom

    dancom Dust Maker Best Shop Tool

    Likes Received:
    1,093
    Trophy Points:
    113
    Hi Russ, Where are you located?
    Did you grab a pound of Kanthal 18 gauge?
    @ToddR

    Dan
     
  3. RussGen

    RussGen New Member

    Likes Received:
    9
    Trophy Points:
    8
    Hi Dan. No it's a pound of 16 guage. I'm in Winnipeg
     
  4. dancom

    dancom Dust Maker Best Shop Tool

    Likes Received:
    1,093
    Trophy Points:
    113
    Hopefully we can steer someone your way.
     
  5. RussGen

    RussGen New Member

    Likes Received:
    9
    Trophy Points:
    8
    It's the wire, pid, k type thermocouple and 2 25 amp ssr's along with the mortared together brick oven. The parts came from 4 different sources, hence 4 return shipping charges. Just one of those bite the bullet situations.
     
  6. John Noon

    John Noon Well-Known Member

    Likes Received:
    621
    Trophy Points:
    113
  7. RussGen

    RussGen New Member

    Likes Received:
    9
    Trophy Points:
    8
    No, I know facebook has a long reach and I'm trying to control who comes knockin. Do you know anything about that. Thanks for the advice
     
  8. John Noon

    John Noon Well-Known Member

    Likes Received:
    621
    Trophy Points:
    113
    The group is pretty good and most people are from the Winnipeg area
     
  9. RussGen

    RussGen New Member

    Likes Received:
    9
    Trophy Points:
    8
    Thanks John, I will try it then
     
  10. ccady

    ccady New Member

    Likes Received:
    4
    Trophy Points:
    3
    Are there any rules for reselling on this forum? I'm in the process of building my own oven as well. When I'm done, I'll also have a whole bunch of leftovers I wouldn't mind getting rid of.
     
  11. John Noon

    John Noon Well-Known Member

    Likes Received:
    621
    Trophy Points:
    113
    Post in classified area
     
  12. John Noon

    John Noon Well-Known Member

    Likes Received:
    621
    Trophy Points:
    113
    On the Facebook group they might have a tailgate page.
    If not check with admin to post sales
     

Share This Page