1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

22ton Press. The New Toy!!

Discussion in 'Other Tools' started by thomas marshall, Dec 30, 2017.

  1. thomas marshall

    thomas marshall New Member

    Likes Received:
    3
    Trophy Points:
    3
    dancom likes this.
  2. james Cuff

    james Cuff New Member

    Likes Received:
    14
    Trophy Points:
    8
    Hi Thomas,

    That is one impressive press ;) I'm just finishing up building a bench top 20-ton air over hydraulic press based loosely on Dan Comeau's design. I still have to mount some springs to help with the jack return rate and finish off a few sets of dies. I designed this press so it can be disassembled as I have very limited working space. The load is contained in the picture frame, with 4 top and 4 bottom 3/4 inch grade 8 bolts. It was fun to build and if I had more space I would build something bigger.

    there is a link to some images.
    https://photos.app.goo.gl/IzkDumGaEI4v0uMN2

    James
     
    dancom likes this.
  3. Shawn Parkinson

    Shawn Parkinson New Member

    Likes Received:
    1
    Trophy Points:
    1
    looks just like a Coal Iron Works press! I like that design. Where did you source all your hydraulic components? I would like to build a press but am a little overwhelmed when it comes to figuring out what and where to get all the hydraulic parts.
     

Share This Page